#1 CONCRETE – PAVEMENT, MANSORY – WALL TILES / BATHROOM

PRIMER ALFA – LEVELING COMPOUND - DUO FLEX

Slide PREMIUM S200 or
RAPID S400
Self - leveling compound for
compensation of height differences
PRIMER ALFA One component
closing penetration
Elastic adhesive &
waterproofing
High quality adhesive that
work as a hydro-isolation
Elastic adhesive &
waterproofing
High-quality adhesive use in
second layer for bonding pavement
PRIMER ALFA One-component closing
penetration suitable
for vertical walls
Elastic adhesive &
waterproofing
High quality adhesive that
work as a hydro-isolation
Elastic adhesive &
waterproofing
High quality adhesive for
bonding tiles
PRIMER ALFA One component
closing penetration

USE CASE OF » CONCRETE » TILES, MANSORY » WALL TILES

– horizontal solution –

STEP #1

PRIMER ALFA – One-component closing penetration apply by brush or roller to the cleaned cohesive layer of the substrate. After drying (approx. 2-3 hours) you can apply self-leveling compound.

STEP #2

PREMIUM S200 or RAPID S400 – Self-leveling compound mix in drinking water. Pour this mixture onto the substrate to compensate for height differences of 2-30mm. Applied material spread with an aluminum lath, trowel, rod, or aeration hedgehog, thereby removing excess air from the applied layer. This mixture dries for approximately 12 hours depending on humidity and temperature.

STEP #3

PRIMER ALFA – One-component closing penetration applies to the leveling compound. It serves to unify the absorbency of the material and create a so-called adhesive bridge between the individual layers. Apply the primer again in the same way as in step #1.

STEP #4

DUO FLEX L8600 – Adhesive serves both for bonding and for creating and waterproofing layer, which is created by applying the smooth side of the trowel (layer 1-2mm max). The waterproofing layer must be applied without defects and evenly over the entire length.

STEP #5

DUO-FLEX L8600 – Can be used to bond tiles or pavement after 24 hours, depending on temperature and humidity. Apply the adhesive layer with a toothed trowel, when the size of the teeth should not be larger than 8x8mm, preferably 4x4mm.

– vertical solution –

STEP #6

PRIMER ALFA – Apply by brush, roller or spray to the cleaned cohesive layer of the substrate. You can use this penetration on the vertical wall as well.

STEP #7

DUO FLEX L8600 – Same as in step #4 adhesive serves both for gluing and for creating and waterproofing layer, which is created by applying the smooth side of the trowel (1-2mm max). The waterproofing layer must be applied without defects and evenly over the entire length.

STEP #8

DUO-FLEX L8600 – Same as in step #5 can be used to bond tiles or pavement after 24 hours, depending on temperature and humidity. Apply the adhesive layer with a toothed trowel, when the size of the teeth should not be larger than 8x8mm, preferably 4x4mm.

CONSUMPTION CALCULATOR

Enter the values

Use:
Area:
m2
Tooth size:
mm
Layer thickness:
mm
PRIMER ALFA:
L
1L PACKAGES:
PCS
S200 OR S400:
KG
25KG PACKAGES:
PCS
DUO FLEX HYDRO ISOLATION :
KG
5KG PACKAGES:
PCS
DUO FLEX GLUING:
KG
5KG PACKAGES:
PCS
SEND OFFER

The above text is for information only. You will find all the instructions in each individual product, where the technical and safety data sheets are located for all the information!